How to configure MDS switch to connect iSCSI Servers (Initaiators) to a FC storage(Target)
Topology
Configuration
|
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 21 22 23 24 25 26 27 28 29 30 |
feature iscsi iscsi enable module 1 iscsi authentication none !! Set PWWN to client IP address iscsi initiator ip-address 10.100.70.150 static pWWN 20:01:00:0d:ec:16:74:42 !! Set virtual target for client iscsi virtual-target name disc.for.iscsi.target-1 pWWN 50:0a:09:82:98:dd:97:bf fc-lun 0x001e iscsi-lun 0x001e advertise interface GigabitEthernet1/2 initiator ip address 10.100.70.150 permit interface GigabitEthernet1/2 ip address 1.1.30.92 255.255.255.0 no shutdown interface iscsi1/2 no shutdown vsan database vsan 30 name "For_iSCSI" vsan 30 interface iscsi1/2 vsan 30 interface fc1/3 !! Configure zones, in this case- allow all zone default-zone permit vsan 30 |
Test
|
1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 |
MDS-1(config)# <strong>show flogi database</strong> -------------------------------------------------------------------------------- INTERFACE VSAN FCID PORT NAME NODE NAME -------------------------------------------------------------------------------- fc1/3 30 0xef0000 50:0a:09:82:98:dd:97:bf 50:0a:09:80:88:dd:97:bf [Disk2] iscsi1/2 30 0xef0001 20:01:00:0d:ec:16:74:42 20:02:00:0d:ec:16:74:42 Total number of flogi = 2. MDS-1(config)# MDS-1(config)# <strong>show iscsi session</strong> Initiator 10.100.70.150 Initiator name iqn.1991-05.com.microsoft:sharon-comp.ucs.lab Session #1 Target disc.for.iscsi.target-1 VSAN 30, ISID 400001370000, Status active, no reservation |